CCM02 Series

The CCM02 Series connectors with landing contacts are dedicated for applications where the reader usage is high and the life span of the card is a key consideration. A connector with contacts which land on the card, rather than slide over it, should be specified so as to minimize card wear. The CCM02 has been redesigned to give an even higher performance in a compact, affordable package.

Features

• 500,000 card insertion cycles.

• The contacts do not touch the card until it is almost fully inserted – A minimal wiping action removes any non-conductive material.

• The connector has been designed to give a positive indication once the card has been fully inserted.

• The reduced size of the contact base saves PCB space, making the connector more stable during surface mounting, and creates an air gap between the contacts and card entry slot, which reduces the risk of an electrostatic transfer to the PCB.

• For added reliability, the integrated card end-travel switch, which is normally open, is sealed against dust and grit.

• By using an inlay finish in the contact area, the life of the precious metal is extended by more than 10 times that of standard gold plating.

• The contact area is spooned to reduce the risk of accidental (or deliberate) damage and to optimize the electrical connection with the card.

• Snap-locks underneath the molding position and hold the connector on the PCB, and give additional support to the contact terminals.

• The plastic moldings are made from a high temperature thermoplastic suited for infrared and convection soldering processes.

1. Contacts Copper alloy

2. Plating Contact area : Gold alloy inlay

3. Terminals: Tin lead (2µ min)

4. Moldings High temp. thermoplastic UL 94V-0 rated

5. Spring Stainless steel

6. Card detection switch actuator Stainless steel

7. Number of Contacts 8

8. Mechanical life 500,000 cycles min

9. Card insertion force 10 N max

10. Card extraction force 1 N min / 10 N max

11. Contact force 0.25 N min / 0.5 N max

12. Card detection switch 0.8 N max for actuation (end travel switch actuation force actuates when card is 1,0 mm from card stop) 1.8 N max for complete depression

13. Vibration Frequency 10 to 500 Hz. Acceleration 50m/s2 Duration 6 hours - amplitude 0,35 mm Max electrical discontinuity 1µs

14. Shock Peak value 500 m/s2 – Duration 11 ms 3 shocks in each direction of each axis Max electrical discontinuity 1 µs

15. Insulation resistance 1,000 MΩ min

16. Resistance 100 mΩ max

17. Current rating 10 µA min / 1 A max

18. Dielectric strength 750 Vrms min

19. Card detection switch Normally open

20. Contact resistance 100 mΩ max

21. Dielectric strength 250 Vrms min

22. Current rating 1 mA min / 10 mA max

23. Maximum power 0.2 VA

24. Operating temperature -40°C to +85°C

25. Soldering temperature Temperature/time profile acc. to CECC00802 para. 6.1, Fig. 3 with peak temperature 250°C

26. Damp heat IEC 512 test number 11c (10 days)

27. Salt mist IEC 512 test number 11f (96 hours)

28. Card detection switch Sealed IP 54